How To Connect A 4 Pin Relay As Indicator Flasher Unit

Is your car’s indicator light giving you trouble? Are you looking for a reliable way to replace it without breaking the bank? A 4 pin relay is an ideal solution. It can be used as an indicator flasher unit and is relatively inexpensive and easy to install. Here, we will explain how to connect a 4 pin relay as an indicator flasher unit, so you can get your car back on the road in no time.

First, you need to identify the correct relay for your vehicle. Most vehicles use a 4 pin relay, but some may require a different type. Once you’ve identified the correct relay, you can begin the installation process.

Next, you need to remove the old indicator flasher unit and the wiring connected to it. This should be done carefully, as to not damage any of the wires or terminals. Then, disconnect the new 4-pin relay from its packaging and attach the wires to the corresponding terminals. Make sure to check the wiring diagram to ensure that the connections are correct.

Once all the wires are connected, you can then mount the relay onto the vehicle. Depending on your vehicle, this could involve securing it with screws or other fasteners. After the relay is installed, you need to connect the power supply to the relay. This is usually done by connecting the positive wire to the "B+" terminal and the negative wire to the "GND" terminal.

Finally, you need to test the relay to ensure that it is working properly. Turn on the ignition, then switch on the indicator lights. If the lights turn on and off as they should, then your new 4 pin relay has been successfully installed.

Installing a 4 pin relay as an indicator flasher unit is a simple process that requires minimal effort. With the right tools and a bit of patience, you can easily get your car back on the road in no time.

Electronic Flasher Unit 12v 4 Pin High Capacity