How To Wire A Slik Stik Control For Meyer Plow

If you have a Meyer Plow and need to wire a Slik Stik Control, you’ve come to the right place. Wiring a Slik Stik Control can be confusing and complicated, but with this guide, you’ll be able to successfully wire your Slik Stik and get your Meyer Plow running in no time.

The first step to wiring your Slik Stik Control is to locate the power wires. The power wires are typically found beneath the hood of the vehicle, near the battery. It’s important to note that these wires should not be connected directly to the battery. Instead, the power wires should be connected to the fuse box, allowing for a more secure connection. Once the power wires are connected, the next step is to connect the ground wire. This wire should be connected to a clean, bare metal surface on the frame of the vehicle.

Next, it’s time to connect the Slik Stik Control to the Meyer Plow. This connection is made through two different harnesses, one for the headlight control, and one for the lift/angle control. Both harnesses should be connected to the corresponding ports on the Slik Stik. Once the harnesses are connected, the last step is to connect the Meyer Plow power wires. These wires will be connected to the designated port on the Slik Stik.

Finally, it’s time to test the Slik Stik Control. To do this, turn the key to the “on” position and press the “test” button on the Slik Stik. The Meyer Plow should go through its motions and if it does, the installation is complete.

Congratulations, you’ve just successfully wired your Slik Stik Control for your Meyer Plow! As you can see, wiring a Slik Stik Control can be a bit tricky, but with this guide, you should be able to get your Meyer Plow up and running in no time.

How To Choose And Install An Atv Snow Plow Finntrail Blog