Wiring Diagram For Double Light Switch Australia

Are you looking to wire up a double light switch in Australia? If so, you’re in the right place. Wiring a double light switch is not as hard as it may seem. With just a few tools and some basic wiring knowledge, you can have your lights up and running in no time. In this article, we’ll walk you through how to wire a double light switch in Australia and the wiring diagram for a double light switch in Australia that you need.

When wiring a double light switch, the first thing you want to do is turn off the power to the circuit at the circuit breaker. Once you’ve done that, you can start to install the wiring. The wiring for a double light switch in Australia is basically the same as for any other light switch. You’ll need two wires from the power source (usually the main panel) to the switch, and then two from the switch to the light.

Next, you’ll need to connect the wires to the switch. Generally, the black wire will go on the common terminal (the one in the middle), and the other colours will go on either side. Once you’ve connected the wires, you’ll need to secure them with a wire nut.

Finally, you’ll need to install the switch in the wall. Make sure to turn off the power to the circuit before doing this, and then use a drill or screwdriver to secure the switch in place. Once you’ve done this, you can turn the power back on and make sure the switch is working properly.

Now that you know how to wire a double light switch in Australia, here’s a wiring diagram for a double light switch in Australia that you can use as a reference. This diagram shows the basic wiring for a double light switch with two switches. It’s important to note that the wiring may be slightly different depending on your specific setup, but this should give you an idea of what to expect.

We hope this article has helped you understand how to wire a double light switch in Australia and the wiring diagram for a double light switch in Australia that you need. If you’re still feeling unsure, it’s always best to get help from a qualified electrician. Good luck!